A raw polarization spectrum is a vector sum of the interstellar polarization spectrum (introduced by interstellar dust grains aligned in the galactic magnetic field) and the intrinsic polarization spectrum. In order to analyse the intrinsic polarization spectrum it is therefore necessary to subtract the interstellar polarization vector. Obtaining a reliable estimate of the interstellar polarization is difficult, but it is crucial to the subsequent analysis since the magnitude of this vector is often significantly larger than that of the intrinsic vector. The wavelength dependence of the interstellar polarization can be described empirically using the Serkowski law (Serkowski 1973):
| (1) |
where is the percentage polarization at wavelength , is the maximum polarization which occurs at wavelength and is a curve width parameter. Originally but it has been suggested that allowing to vary may improve the fit (Condina-Landaberry & Magalhães 1976 and Whittet et al 1992).
The command ISFIT uses a non-linear least-squares method to fit a Serkowski law (equation 1) to the data in the current arrays. The four parameters to this command are , the maximum Stokes polarization, , the maximum Stokes polarization, , the wavelength of the maximum polarization and the curve width parameter. A free parameter is initialised with the symbol and a parameter to be held fixed is defined using the symbol. A typical command line may look like:
This command holds at but , and are free parameters. These parameters are used to create a polarization spectrum at the wavelength bins defined by the spectrum in the current arrays. This means that the spectrum in the current arrays is lost. Errors are reported if the number of free parameters exceeds the number of available polarization datum.
The interstellar polarization vector can be removed from the target spectrum using the SUBTRACT command. The polarization spectrum in the current arrays is subtracted from the specified entry. The subtraction is performed over the overlapping wavelength region. The Stokes spectrum is obtained from the stack polarization spectrum and linear interpolation is used to regrid the stack polarization spectrum onto the current wavelength array. The resulting polarization spectrum is placed in the current arrays.
Other useful commands for adding and subtracting polarization vectors include STATADD and STATSUB, which add/subtract a constant vector found using the PTHETA command. The ICADD command adds a constant value to the Stokes spectrum only, thereby diluting the polarization.