FLT.CLIP

Speeds up convergences and reduces ringing by excluding sharp features in the bolometer time streams from the filtering performed by the FLT model

Description:

If this parameter is non-zero, each bolometer time stream is examined for sharp features prior to applying the hi-pass filter specified by parameter "flt.filt_edge_largescale" etc. Any such sharp features are replaced by a linear function joining the data values before and after the sharp feature. Sharp features are found by first smoothing the time stream using a simple box kernel with a width corresponding to the largest features passed by the FLT filter. The RMS of the residuals between the smoothed and original time stream is then found. Any samples that have residual greater than " flt.clip" times the RMS are set bad. Additional samples equivalent to 0.25 of the filter size are also set bad on either side of a clipped sample. If any such samples are found, the process is repeated (i.e. the remaining data is smoothed, the RMS residual recalculated and the check for outliers repeated). Once no further outliers are found, the bad data values are replaced by values that interpolate the adjoining good values using a linear function.

The value supplied for this parameter can optionally be a comma-separated list of two clipping levels enclosed in parentheses. In this case the first clipping level is used as described above. The second clipping level should be smaller than the first. It is used in much the same way as the first clipping level, except that points that would be clipped using the second clipping level are only clipped if at least 3 of the 5 nearest neighbours (including the point itself) are above the second clipping level.

This parameter is used to prevent the ringing that would otherwise be caused by the action of the filter on the sharp features. It should usually be seen as an alternative to the masking controlled via the " flt.zero_" set of parameters. Note, in some cases it may slow down convergence due to the fact that each bolometer is masked independently of the sky, thus reducing the consistency between each bolometer and the sky map.

Note, the masking described above can be restricted to selected iterations by setting a value for the parameter "flt.zero_niter" . [0.0]

Type:
real

SMURF Usage

MAKEMAP, CALCQU